Some systems support user configuration. Follow the instructions below to enter configuration mode.
Note: Some configuration features may require the C220 to be powered up and linked with the H212/H106 before any changes can be made.
Make sure the H212/H106 handheld is powered off. Then:
- Press and hold the Red button
- Press and hold the Green button
- Release the Red button
- Continue holding the Green button for a few more seconds until the two LEDs become solid.
- Release the Green button immediately after the red LED turns solid.
DO NOT CONTINUE TO HOLD THE GREEN BUTTON AFTER THE RED LED TURNS SOLID OR ELSE YOU MAY NOT BE ABLE TO SAVE ANY SETTINGS.
Some systems will require a password. Please contact our support team for details.
You should now be in Config mode. Left/Right scrolls through the list of available settings. Up/Down selects the options for each setting. Once you are satisfied, press the Green button to save your options or the Red button to cancel and exit.
After saving, exit the config mode by pressing the Red button.
Power up the system normally and your new settings will be active.
For further assistance, please contact technical support:
support@aarcomm.com
1-604-265-8500
1-800-604-9218
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article