Some Trucks have a LoadMaxx system that can measure the weight of load on the truck, but, if a truck does not have this added system or it isn't connected it can display itself as a CAN error on the remote.
To remove CAN error from the screen, first get into the Configuration mode on the remote.
Configuration mode article: Configuration Mode
after getting into config mode:
- Scroll on the menu by pressing on either the left or right buttons
- until you see "LoadMaxx" parameter
- switch "Enabled" to "Disabled"
- Save Parameters by pressing the green button
when Pressing the Green button to save parameters give the remote some time to save settings before restarting the remote.
Wait until the remote says Params saved.
now that the parameters are saved you can exit the configuration mode by pressing the red button
power up the system normally and the new settings will be active, and the CAN error will be gone.
For further assistance, please contact technical support:
support@aarcomm.com
1-604-265-8500
1-800-604-9218
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article